DP71
14
2. Windows
R
2000
Automatic Installation Procedure
1. Ensure that the PCI interface board is installed in the PCI
card slot of the computer.
2. Start Windows 2000. (Log on with the Administrator authority.)
3. When the following window appears in a while, click on the
[Cancel] button to close the window.
4. Go to section (“ 2 Installing the Application Software”
on page 17.
The device driver will be installed automatically during
installation of the application software.
Manual Installation Procedure
1. Ensure that the PCI interface board is installed in the PCI
card slot of the computer.
2. Start Windows 2000. (Log on with the Administrator authority.)
3. When the following window appears in a while, click on the
[Next] button.
4. Check [Search for a suitable driver for my device
(recommended)] and click on the [Next] button.
5. Place the CD-ROM in the CD-ROM drive.
6. Check only [Specify a location] (be sure to uncheck other
options), and click on the [Next] button.
To Next Page
Loading...
