DMTA-10083-01EN, Rev. 3, June 2017
Chapter 2
28
2.1.1 AC Adaptor Connector
The AC charger/adaptor connects to the AC adaptor connector of the EPOCH 6LT to
power the instrument and charge the battery.
2.1.2 LEMO Transducer Connectors
The EPOCH 6LT is supplied with sealed LEMO 00 transducer connectors. A center
pin automatically identifies the connected transducer with certain Olympus corrosion
dual element transducers.
The transducer connectors are color coded red and blue. When used with dual
element transducers and in through-transmission modes, the red LEMO 00 connector
acts as the transmit connector and the blue LEMO 00 connector acts as the receive
connector.
For single crystal pulse-echo inspections, you must connect the transducer to the red
LEMO 00 (transmit) connector to send and receive a signal.
Figure 2‑2 Color‑coded LEMO connectors
2.2 Battery Compartment
The battery compartment cover is located at the bottom of the instrument (see
Figure 2-3 on page 29).
Receive connector
Transmit connector
To Next Page
Loading...
