DMTA-10083-01EN, Rev. 3, June 2017
Chapter 3
36
3.3 Connecting the AC Charger/Adaptor
Connect the AC charger/adaptor directly to the EPOCH 6LT to power the instrument.
When a Li-ion battery is installed in the instrument, and the AC charger/adaptor is
connected, the battery charges until full. For information on charging the battery in
the external charging base, see “Charging Base” on page 24. Note that the AC
charger/adaptor is intended for indoor use only.
To connect the AC charger/adaptor
1. Plug the DC power plug into the AC charger/adaptor connector on the
instrument (see Figure 3-1 on page 36).
Figure 3‑1 Connecting the DC power plug
2. Insert the other end of the AC power cord into the AC connector on the AC
charger/adaptor (see Figure 3-2 on page 37).
To Next Page
Loading...
