Olympus EPOCH 6LT - Digital Video Connector; USB a Connector; Mini USB Connector; Reset Switch

DMTA-10083-01EN, Rev. 3, June 2017
Chapter 2 30
2.3.1 Digital Video Connector
The Digital Video connector is used to connect the EPOCH 6LT to an external digital
display via a compatible cable (optional). The Digital Video cable must have one L20
ferrite bead on each end of the cable to be CE compliant.
2.3.2 USB A Connector
The USB A connector is used to connect the EPOCH 6LT to a USB storage device. The
USB A connector must be used with the Olympus USB drive or equivalent to be CE
compliant.
2.3.3 Mini USB connector
The mini USB connector is used to connect the EPOCH 6LT, via the supplied USB
cable, to a PC for data transfer.
2.3.4 Reset Switch
The Reset switch is used to reset the system software in the event of a catastrophic
software failure.
2.3.5 Accessory Mount
The accessory mount is a standard ¼ in.-20 thread insert, which is located on the
bottom of the instrument (see Figure 2-5 on page 30). Multiple mechanical accessories
can be used with this mount, including the Olympus rope access accessory kit.
Figure 2‑5 Accessory mount
Accessory mount point