19
EN
1 The control panel shows the light control
range according to the camera’s setup.
2 Confirm that the distance to the subject
is within the light control range.
If it is not within the light control range,
change the distance to the subject or the
camera’s setup.
The light control range varies according
to the camera’s setup (ISO sensitivity,
aperture value, lens focal length and
shutter speed).
3 When flash activation has been
performed correctly, the AUTO CHECK
lamp blinks for about 5 seconds after
the shutter is released.
Mode
Light control
range
Firing angle
AUTO CHECK
lamp
x
Notes
With Super FP flash the highest guide number will be lower than in TTL
AUTO mode. As a result, the light control range will be shortened.
r2067e000cs2j.indb19r2067e000cs2j.indb19 2007/10/0110:49:522007/10/0110:49:52
To Next Page
Loading...
