Olympus FL 36R - Continuous Firing; Limit Counts and Intervals

47
EN
Continuous firing
For your safety,
be sure to observe the following.
Continuous firings make the light-emitting section hot and may result
in its deterioration, malfunction or deformation. Therefore, continuous
firing should be limited to the counts shown in the following table.
Always leave the electronic flash unused for at least 10 minutes after
continuous firing up to the limit count.
Limit counts of continuous firings
Flash intensity Flash interval Limit count
FULL; 1/1 6 sec. 10
1/2 3 sec. 20
1/4 1 sec. 40
1/8 - 1/128 0.5 sec. or less 80
r2067e000cs2j.indb47r2067e000cs2j.indb47 2007/10/0110:49:562007/10/0110:49:56