Olympus FL-600R - Using with Non-Communicating Cameras; AUTO Mode for Non-Communicating Cameras; MANUAL Mode for Non-Communicating Cameras

20 EN
Cameras That Do Not Communicate with the Flash
Cameras That Do Not Communicate with the Flash
AUTO
AUTO
Set aperture and ISO sensitivity to the values selected with the camera.
1
Set the fl ash control mode to AUTO.
g “Flash control mode” (p. 11)
2
Match the zoom position to the focal length of the lens.
g “ZOOM” (p. 13)
3
Adjust aperture and ISO sensitivity.
g “Other settings” (p. 17)
If the selected values are out of the fl ash control range, [ISO] and [F] will blink in the display.
The AUTO CHECK lamp blinks for about 5 s after the shutter is released to show that the
fl ash has fi red successfully.
MANUAL
MANUAL
Choose the guide number.
1
Set the fl ash control mode to MANUAL.
g “Flash control mode” (p. 11)
2
Adjust fl ash level.
g “Other settings” (p. 17)
bookR219110LEur.indb20bookR219110LEur.indb20 2012/01/1322:34:082012/01/1322:34:08