Olympus FL-600R - Slave Mode Operation; Setting Slave Modes

EN 21
Slave Mode
Slave Mode
The fl ash can be fi red remotely in sync with any fl ash fi red by other units.
1
Set the fl ash control mode to SL AUTO or SL MANUAL.
g “Flash control mode” (p. 11)
Adjust other fl ash settings as for AUTO or MANUAL mode.
g “Cameras That Do Not Communicate with the Flash” (p. 20)
2
Position the fl ash.
See the camera manual for more information.
• The fl ash can not be used with cameras that require a pre-fl ash.
• The fl ash may fi re in response to fl ash units used by other
photographers.
bookR219110LEur.indb21bookR219110LEur.indb21 2012/01/1322:34:082012/01/1322:34:08