Olympus FL-700WR - Firing the Flash at a High Shutter Speed (FP TTL Mode; FP M Mode); Setting the firing angle (ZOOM); Setting the flash intensity (RATIO)

44
EN
Setting the fi ring angle (ZOOM)
Press the ZOOM button to highlight ZOOM. Then, turn the dial to adjust the
setting.
• When you select A (auto), an automatic setting takes effect. The automatic
setting ranges from 12 mm to 75 mm.
• When the fl ash window is adjusted for bounce fl ash photography, you cannot
select A (auto).
• When you select M (manual), you can set a fi ring angle from 12 mm to 75 mm.
Press the OK button.
Setting the fl ash intensity (RATIO)
Press the a button to highlight RATIO. Then, turn
the dial to adjust the setting.
• You can set a fl ash ratio from 1/1 to 1/128.*
1
Scale display*
2
MODE LEDZOOM
A
mm25
–
Off
M
M
RATIO
1/100
DISTANCE
2.5
m
1/32
1/64
1/128
*1 You can select 1/2 EV or 1/3 EV for the adjustment
increment. (P. 60)
*2 On the scale display, t is the current selection. u is the
previous setting.
Press the OK button.
• If you switch to the M mode after you shoot with the fl ash in the TTL mode, the
previous fl ash intensity will become the manual fl ash intensity.
Firing the Flash at a High Shutter Speed
(FP TTL Mode / FP M Mode)
You can shoot with the fl ash at shutter speeds faster than the fl ash sync
speed. These modes are useful when you want to shoot a portrait with a blurry
background by widening the aperture, or when you want to use a high shutter
speed to reduce blown-out highlights in the background.
The guide number is lower than in the regular TTL mode or M mode.
1
Press the MODE button. Then, turn the dial to
select FP TTL or FP M. Press the OK button to
confi rm.
MODE LEDZOOM
A
mm750.0
Off
M
RANGE
1.4~5.5
m
TTL
FP
2
Adjust the settings.