Olympus FL-700WR - Firing the Flash Repeatedly at a Regular Interval (MULTI Mode); Setting the firing angle (ZOOM); Setting the flash intensity (RATIO)

45
EN
Setting the fl ash compensation (#+/-) in the FP TTL mode
Press the a button to highlight #+/-. Then, turn the dial to adjust the
setting.
• You can set a fl ash compensation from -5 to +5.
Press the OK button.
Setting the fi ring angle (ZOOM)
Press the ZOOM button to highlight ZOOM. Then, turn the dial to adjust the
setting.
• When you select A (auto), an automatic setting takes effect. The automatic
setting ranges from 12 mm to 75 mm.
• When the fl ash window is adjusted for bounce fl ash photography, you cannot
select A (auto).
• When you select M (manual), you can set a fi ring angle from 12 mm to 75 mm.
Press the OK button.
Setting the fl ash intensity (RATIO) in the FP M mode
Press the a button to highlight RATIO. Then, turn
the dial to adjust the setting.
• You can set a fl ash ratio from 1/1 to 1/128.*
1
Scale display*
2
MODE LEDZOOM
A
mm25
–
Off
M
M
FP
RATIO
1/100
DISTANCE
2.5
m
1/32
1/64
1/128
*1 You can select 1/2 EV or 1/3 EV for the adjustment
increment. (P. 60)
*2 On the scale display, t is the current selection. u is the
previous setting.
Press the OK button.
Firing the Flash Repeatedly at a Regular
Interval (MULTI Mode)
In this mode, the fl ash fi res multiple times at a regular interval during a single
exposure. You can capture the subject’s movement in a single image. The
maximum number of fi rings varies according to the setting for fl ash intensity.
Normally, this kind of shooting uses a slow shutter speed of 60 seconds or
shorter. You can only set this mode with Olympus cameras that support the multi-
fl ash feature.
1
Press the MODE button. Then, turn the dial to
select MULTI. Press the OK button to confi rm.
MODE LEDZOOM
A
mm75
–
Off
M
MULTI
Hz
10
TIME
51/128
RATIO
2
Adjust the settings.