IBEFORE USE
Observe the following points carefully for operation and maintenance:
1.
Operation
@ As a microscope is a precision instrument, always handle
it with the care it deserves, and avoid abrupt motions
and shocks.
0
a
0
0
8
0
2.
To lift the microscope from the packing case, hold it
at the OM mount (A) and the fluorescence illuminator
mounting thread (B). (Fig. 1)
To move the microscope
Hold the microscope by the OM mount (A) and the
fluorescence illuminator mounting thread (B) or place
your hands under the microscope base at the microscope
side (C) and back (D).
Do not grasp the plastic hand rests, since they are not
strong enough to support the microscope.
Do not use any bulb other than the one designated by
Olympus (12V50WHAL halogen bulb).
Avoid exposure of the microscope to direct sunlight,
(Model IMT2SFR shown)
high temperature and humidity, dust and vibration.
Make it a point to use the tension adjustment ring to adjust the tension of the coarse adjustment knobs. (
not rotate the coarse adjustment knobs in the opposite directions simultaneously.)
Make sure that the line voltage selector switch is set to conform with the local mains voltage.
Disconnect the power cord from the AC outlet before fuse replacement.
Always ground the microscope.
Maintenance
:Do
@ Lens surfaces must always be kept clean. Fine dust on lens surfaces should be blown off by means of a hand
blower. Carefully wipe off oil or fingerprints on the lens surfaces with gauze moistened with a small amount
of xylene, or a cleaning medium (alcohol and ether 3 : 7).
@ Do not use organic solutions to wipe the surfaces of various plastic components.
@ Be careful not to spill the culture solution, etc. If spilt, it should be wiped off immediately. It is recommended
to use a waterproof cover optionally available.
@ When objectives are not screwed into the nosepiece apertures, seal the apertures with dust plugs, which will
protect the lenses located in the lower light path from dust, culture solutron, etc.
@ After use the microscope should be covered with the vinyl dust cover provided and stored in a place free from
humidity.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
