143
Chapter 6 Measurement procedures
List of messages displayed in the operation instructions message box and the measurement results
message box
Message Description
Å
PUT
M##
Specify measurement point number ## in the input area in the left image.
Å
PUT
R##
Specify reference point number ## in the input area in the left image.
Å
MODIFY
Measurement point for modifying is selected in the input area in the left
image.
Æ
MODIFY
Measurement point for modifying is selected in the input area in the right
image.
Å
MODIFY
M##
Measurement point ## is being modified in the input area in the left image.
Æ
MODIFY
M##
Measurement point ## is being modified in the input area in the right image.
Å
MODIFY
R##
Reference point ## is being modified in the input area in the left image.
Æ
MODIFY
R##
Reference point ## is being modified in the input area in the right image.
OVER
20 PNTS
Up to 20 measurement points can be specified in the measurement region.
CLOSE
AREA
Close the measurement area.
NONFUNC The function of this button is disabled.
WORKING Please wait while the system is working.
WRONG FIG Area measurement cannot be performed for the shape.
Measurement
unsuccessful.
Please retry.
Measurement is not possible if the reference point or image is not suitable for
Multi. Change the reference points or capture the image again and then try
measuring again.
To Next Page
Loading...
