Why doesn't the stereo measurement function start on my Olympus Industrial Equipment?
If the stereo measurement function does not start, verify that the combination of the stereo optical adapter and the stereo scope unit is correct by checking their serial numbers.
What should I do if my Olympus Industrial Equipment displays
If your device shows this message, it means the SDHC card or USB flash drive is full. You should delete any unnecessary data to create more space, or replace it with a new SDHC card or USB flash drive.
Why is my Olympus IPLEX NX IV9635N Industrial Equipment image not sharp?
The lack of sharpness may be due to a dirty objective lens on the distal end of the insertion tube or the optical adapter. Try wiping it with a clean piece of gauze or a cotton swab. Also, ensure the optical adapter is correctly attached and that both the image sharpness and external monitor are properly adjusted.
What to do if Olympus IPLEX NX IV9635N Industrial Equipment displays
This message indicates that the battery voltage is low. Stop all operations like recording, copying, deleting, or formatting the USB flash drive. Replace the battery immediately or connect the AC adapter.
Why is the measurement result of the scaler measurement not displayed on my Olympus IPLEX NX IV9635N?
If the measurement result of the scaler measurement is not displayed, it may be due to using an image acquired by an unsupported software version (1.20 or before). Use an image acquired by software version 1.20A or later.
What to do if Olympus IPLEX NX IV9635N Industrial Equipment displays
Only images recorded with this instrument can be displayed.
Why does my Olympus IPLEX NX IV9635N optical adapter not attach to the insertion tube?
The inability to attach the optical adapter could be due to a foreign object stuck to the screws. Try wiping with a clean piece of gauze or a cotton swab. It could also be that you are not using the designated optical adapter for this system, so ensure you are using the correct adapter. Finally, the installation procedure may be incorrect.
Why won't my Olympus IPLEX NX IV9635N Industrial Equipment turn off?
If the system cannot be turned off, the main unit might be damaged. Remove the AC adapter or the battery from the main unit and turn OFF the power.
What to do if Olympus IPLEX NX IV9635N displays
This message indicates that the self-check function was activated due to an overcurrent in the light source. Terminate the inspection, allow the instrument to cool down, and then turn the power back on again.
What to do if Olympus IPLEX NX IV9635N Industrial Equipment displays
This message indicates that the distal end has become too hot, activating the self-check function. Immediately pull the insertion tube out of the observation object.
General guidelines and warnings for safe handling and operation of the instrument.
Specific safety instructions for handling and attaching the hook assembly.
Important safety guidelines for handling and using the instrument's battery.
Instructions for preparing the instrument's power source, battery or AC adapter.
Checklists for inspecting the instrument before and after use.
Step-by-step guide on how to power on the instrument.
Procedure for verifying measurement accuracy before and after operations.
Detailed steps for performing measurements using different methods.
Guidance for diagnosing and resolving common instrument issues and error messages.
General| Brand | Olympus |
|---|---|
| Model | IPLEX NX IV9635N |
| Category | Industrial Equipment |
| Language | English |
To Next Page
