EasyManua.ls Logo

Olympus IX81-ZDC2 - Specifications

Olympus IX81-ZDC2
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
11
SPECIFICATIONS
4
Item Specification
Applicable microscope frame IX81F-ZDC2, IX81S1F-ZDC2
Applicable observation tubes U-BI90-CT, U-BI90, U-TBI90, U-TR30H (in combination with the IX-ATU)
Applicable control box IX2-UCB (Control board and Application Software for PC (see page 1) are required.)
Controller PC
Focus detection method
Pupil-division reflection active autofocusing using a laser diode and 2-division detector.
Laser diode: 785 nm (Class 1: IEC60825-1, Class I : CDRH)
Laser pulse duration: 0.5 to 2.5 ms.
Frequency: 100 Hz. Momentary maximum output power; 127.5 [µW]
Applicable objectives Refer to the list of applicable objectives (page 4).
Observation method Reflected light fluorescence observation is recommended. TIRF. DIC (compatible only with
one-shot focus)
* The focus drift compensation function is not applicable to the phase contrast and polarized
light observations.
Field number 22
AF focusing speed
(One-shot focus mode only)
Approximately 1 to 5 sec. from the focusing range (Excluding the offset drive time)
(Note: The AF speed may slow down depending on the PC setup.)
AF repeatability · 20X and 40X objectives:
±0.1 µm (with constant temperature),
±0.17 µm (with less than 5°C temperature change)
· 60X objective or 40X/60X/100X oil-/water-immersion objectives:
±0.07 µm (with constant temperature),
±0.1 µm (with less than 5°C temperature change)
Dimensions & weight
IX81-ZDC2 system : 303 (W) x 313 (H) x 434 (D) mm., 19.2 kg (42.2 lb)
AF sensor unit : 76 (W) x 76 (H) x 201 (D) mm., 0.9 kg (2 lb)
* Image-forming lens section/excluding the connector
Operating Environment · Indoor use.
· Altitude: Max. 2000 meters.
· Ambient temperature: 18 to 40°C (64.4 to 104°F)
· Maximum relative humidity: 80% for temperatures up to 31°C (88°F), decreasing linearly
through 70% at 34°C (93°F), 60% at 37°C (99°F), to 50% relative humidity at 40°C (104°F).
· Supply voltage fluctuations: ±10%.
· Pollution degree: 2 (in accordance with IEC60664)
· Installation (overvoltage) category: II (in accordance with IEC60664)

Related product manuals