Olympus Mju 1050 SW - Page 47

47 EN
Make the settings for the functions while referring to “Using the Menu” (p. 3).
To play back camera images on a TV
1 ConnecttheTVandcamera.
ConnecttotheTVvideo
inputjack(yellow)and
audioinputjack(white).
Multi-connector
AVcable(supplied)
Connectorcover
2 UsethecameratoselectthesamevideosignalsystemastheoneofconnectedTV([NTSC]/
[PAL]).
3 TurnontheTV,andchange“INPUT”to“VIDEO(aninputjackconnectedtothecamera).”
 FordetailsonchangingtheinputsourceoftheTV,refertotheTV’sinstructionmanual.
4Setthemodedialtoq,anduse1234 toselecttheimageforplayback.
 DependingontheTV’ssettings,thedisplayedimagesandinformationmaybecomecropped.
Saving battery power between shots
[POWER SAVE]
xSETUPPOWERSAVE
Submenu 2 Application
OFF Cancels[POWERSAVE]
ON
Whenthecameraisnotbeing
usedforapprox.10seconds,the
monitorautomaticallyturnsoffto
savebatterypower.
To resume standby mode
Pressanybuttonorturnthemodedial.
Using the LED illuminator as an
auxiliary light [LED ILLUMINATOR]
xSETUPLEDILLUMINATOR
Submenu 2 Application
OFF DisablestheLEDilluminator.
ON EnablestheLEDilluminator.
 “Using the LED illuminator” (p. 23)