Olympus SZX16 - Camera Observation and Photomicrography; Camera Setup and Light Path Configuration

13
SZX16
4-4 Camera Observation and Photomicrography
Set the magnification of the camera adapter according to the size of the CCD in the digital camera.
(Example) The following figures show the camera observation/photomicrography areas when the WHN10X
eyepieces with FN 22 are used.
A digital camera unit can be mounted on the straight tube mount of the trinocular tube by means of the camera
adapter and/or camera mount adapter*.
* The camera mount adapter is not necessary if a camera adapter equipped with a camera mount is used.
For details, please also read the instruction manuals for the camera adapter and digital camera.
Using the Allen screwdriver, fully loosen the straight tube clamping
screw
a
of the straight tube mount on the top of the trinocular tube.
Fit the round dovetail
b
of the camera adapter into the straight tube
mount of the trinocular tube, and tighten the clamping screw
a
.
Mount the camera on the camera adapter. A camera mount adapter
may be required with certain camera adapters.
1
2
3
Pull out the light path selector knob
c
to select the Binocular 50%/
Camera 50% light path setting for the SZX2-TR30/TTR or the Camera
100% light path setting for the SZX2-TR30PT/TTRPT.
1
Selecting the Camera Adapter Magnification
2
Mounting the Camera Adapter
3
Selecting the Camera Light Path
1 in. CCD
2/3 in. CCD
1/2 in. CCD
WHN10X
FN 22
When the 0.5X camera adapter is used When the 1X camera adapter is used
a
c
b
Downloaded from ManualsNet.com search engine