Olympus SZX16 - Revolving Nosepiece Assembly and Operation

23
SZX16
2
Assembly
b
Remove the observation tube from the zoom microscope body.
Remove the zoom microscope body and focusing assembly from the
pillar, and place them upside down on a flat desk surface.
Place a soft sheet made of rubber or similar material on
the desk surface.
Remove the objective from the zoom microscope body and then
remove the objective mount
b
by loosening the three clamping
screws
a
using the provided Allen wrench (for M3 screws).
1
2
NOTE
3
9-2 Revolving Nosepiece SZX2-2RE16
The revolving nosepiece allows two objectives to be mounted (deviation in focusing due to switching
between the objectives can be minimized provided that both of them are of the PF series). This makes
objective switching easy by simply rotating the revolving nosepiece and expands the range of observation
magnifications.
TIP
1
External View
Hand guard
Allen wrench
(for M3 screws)
Clamping screws
(M3, 6 mm long, x 4)
Nosepiece mount Objective mounts
a
Downloaded from ManualsNet.com search engine