Olympus SZX16 - Eyepiece, Stage Plate, and Specimen Holder Installation; Microscope Body Positioning on Stand

21
SZX16
6
Mounting the Eyepiece
7
Mounting (Removing) the Stage Plate
8
Mounting the Specimen Holder
9
Positioning the Microscope Body on the Stand
b
a
a
c
a
b
b
When using the micrometer eyepiece disk, insert it in the
right eyepiece. (It may be inserted in the left eyepiece but the
description in this manual assumes that it is inserted in the
right eyepiece.)
Remove the eyepiece dust caps
a
and loosen the eyepiece clamping
screws
b
completely.
Gently insert the eyepieces of the same magnification
c
into the left
and right eyepiece sleeves all the way until they stop.
Tighten both eyepiece clamping screws
b
.
TIP
1
2
3
Place the stage plate into the mounting hole on the base.
To remove, press the stage plate at the edge nearest to the pillar
with your fingertip. The opposite end will rise from the base so the
stage plate can be picked up easily.
Use the specimen holder when you want to hold the
specimen so that it will not move.
Insert the specimen holder
a
into the two holes
b
on the
top surface of the base.
TIP
Loosen the focusing assembly clamping knob
a
. Slightly pivoting the
microscope body to the left and right, align the center of the objective
with the center of the stage plate
b
, then clamp the microscope body
with the focusing assembly clamping knob.
Downloaded from ManualsNet.com search engine