To Next PageTo Next PageWhat to do if the Olympus U-LH100HG Microscope mercury burner flickers or is dark?
If the mercury burner flickers or is dark on your Olympus Microscope, it could be due to several reasons. If it is soon after ignition, allow it to run for at least 10 minutes. If the hour counter indicates 300 hours (USH-103OL, HBO103W/2), replace the mercury burner. You may also need to center the mercury burner.
Why does the Olympus U-LH100HG field contain dark, spot-like areas?
If the field of your Olympus Microscope contains dark, spot-like areas, it is likely due to dirt or dust on the burner or on the burner side of the collector lens. Clean these components to resolve the issue.
General| Brand | Olympus |
|---|---|
| Model | U-LH100HG |
| Category | Microscope |
| Language | English |
Safety guidelines for handling the precision instrument system.
Guidelines for safe and proper operation of the reflected fluorescence system.
Instructions for cleaning components and proper storage of the equipment.
Warnings about improper usage that may lead to injury or damage.
Identification and diagram of the reflected fluorescence system components.
Step-by-step guide for performing reflected fluorescence observations.
Detailed instructions for operating the various controls of the system.
Methods for combining reflected fluorescence with other observation techniques.
Common problems and their solutions for the fluorescence system.
Graphs showing the spectral transmission of various filters used in the system.
Technical specifications for the vertical illuminators and mercury lamp housing.
Details on mounting and using the 6-position filter slider for excitation and ND filters.
Instructions for mounting and using the 6-position barrier filter slider.
Description and installation of the rectangular field stop accessory.
How to use exciter balancers for adjusting excitation light intensity of fluorochromes.
Diagram illustrating the sequence of assembling microscope modules.
Step-by-step instructions for attaching fluorescence mirror units.
Overview of components for reflected observation systems using the BX-URA2.
Assembly procedures specific to certain items not covered with fluorescence modules.
Procedures for adjusting field and aperture iris diaphragms for reflected observation.
Procedures for various types of reflected light observations.
How to set up and perform brightfield and darkfield observations.
Steps for performing Nomarski DIC observation under reflected light.
Procedure for simple polarized light observation using the reflected illuminator.
Explanation of how objective names are structured and what they signify.
Definitions of terms used in optical characteristics tables.
Troubleshooting common issues in reflected light observation modes.
Details on voltage, current, and fittings for power supply cords.
List of agencies and certification marks for approved power supply cords.
