EN 27
EN
Drying the flash
After washing the flash, dry it with a clean, soft, lint-free cloth. Then, leave
it to dry completely in a well-ventilated location protected from direct
sunlight.
Perform maintenance on the O-ring
Always carry out maintenance on the O-ring after use, to maintain
optimum waterproofing performance.
See “2. Maintaining the Waterproof Function” (gP.14)
Replace consumable products
• The O-ring is a consumable product. Independent of the number of
times the flash is used, it is recommended that the O-ring should be
replaced by a new one at least once a year.
• Deterioration of the O-ring is accelerated by the conditions of use and
the storage conditions. Replace the O-ring even before a year has
passed if it shows signs of damage, cracking or loss of elasticity.
Note :
Moisten a towel etc. in advance with pure water and keep it in a plastic bag so
that you can wipe the salt from your hands and fingers before handling the
flash.
CAUTION
• Never use hot air from a hair dryer or other appliance to dry the flash. This
could deteriorate or deform the flash and O-ring and lead to water
penetration.
• When wiping the flash, take care not to scratch it.
Note :
Please use original Olympus silicone O-ring grease and the O-rings. These
products can be purchased at an Olympus service station.
UFL-3_EN.book Page 27 Thursday, July 17, 2014 5:21 PM
To Next Page
Loading...
