Section 4 - Laser Sight Accessory
4.1 Warning and Cautions
You may receive harmful laser radiation exposure if you do not adhere to the warnings listed
below:
• Use of controls or adjustments or performance of procedures other
than those specified here may result in hazardous radiation exposure.
• Do not look at the laser beam coming out of the lens or view directly
with optical instruments - eye damage can result.
• Use extreme caution when operation the laser sight accessory
• Never point the laser accessory at a person
• Keep out of the reach of all children
Do not attempt to open the laser sight accessory. There are no user serviceable parts inside.
4.2 Operating the Laser Sight Accessory
The laser sight accessory screws onto the front of the sensor head. This
accessory is only used for alignment of the sensor head to the target area.
After the alignment process, the accessory has to be removed from the
front of the sensor head before temperature measurement.
The laser sight accessory is powered from a small compact battery pack
(included with the accessory). Connect the battery pack to the accessory
using the cable provided. Aim at the target, and turn on the battery power
using the slide switch on the battery pack. Adjust the sensor head position
so that the laser beam points to the center of the target area. Turn off the
battery pack, and remove the laser sighting accessory from the sensor
head. See Fig. 4-1 for reference.
OS100 Series - Laser Sight Accessory
4
4-1
CAUTION:
WARNING:
To Next Page
Loading...
Need help?
General
