5
• Use correct fuse only: T10AH 250V.
• Do not insert conductive parts (screwdrivers etc.) into the sockets.
• Do not operate in a wet or humid environment (condensation).
• Do not operate if an explosion hazard exists.
• Do not operate if you suspect that a hardware fault exists. In this case,
please contact OMICRON electronics.
• Take note of the important instructions for proper handling of the
CMA 156 before starting it up
(page 10).
The device may only be opened at the manufacturer's factory - if
irregularities occur, please send it to us. Voltages of up to 500 V will
occur inside the unit! If the unit is opened, warranty claims will become
void.
If the mains fuse must be replaced (back panel of the device):
First disconnect the mains plug of the CMC test device!
Unscrew the little plastic tile and change the fuse.
Fuse: T10AH 250V.
To Next Page
Loading...