50
Test .......................................................................... 23
Heating of the hardware ............................................... 23
I
IEC 1010-1 .................................................................. 44
IEC68-2-27 .................................................................. 43
IEC68-2-6 .................................................................... 43
Important instructions .............................................. 10
Inputs and Outputs
Ampl in ............................................................. 30, 42
Ampl. out ................................................................. 32
Isolation of .............................................................. 22
Interconnection
Block diagram ......................................................... 15
of components ......................................................... 12
Interface ....................................................................... 24
Assignment of Ampl. in .......................................... 31
International standards ................................................. 44
Isolation ....................................................................... 22
Input output ........................................................ 42
Isolation amplifier .................................................. 20, 22
L
LED indicators ............................................................. 20
Possible operating states .......................................... 38
Lemo plug
Assignment of plug to Ampl. in .............................. 31
Length
of the test cable .......................................................... 4
Load too high ............................................................... 20
M
Mains
Connection .............................................................. 28
Supply ..................................................................... 39
Mains fuse...................................................................... 5
Maintenance ................................................................. 3
Manufacturers
of plugs .................................................................... 33
OMICRON .............................................................. 48
Mechanical data ........................................................... 44
Messages .................................................................. 38
Modules
Description .............................................................. 20
Monitoring facilities .................................................... 22
Monitoring the device .................................................. 20
N
Nominal frequency .......................................................39
O
OMICRON
Contact information .................................................48
Opening the device....................................................... 5
Ordering information
Plug Manufacturers ..................................................26
Ordering Information ....................................................45
Output current too high .................................................20
Output power ................................................................41
Outputs .........................................................................40
Overcurrent ............................................................. 20, 38
Overheating ............................................................ 20, 38
Overload .......................................................................38
Display .....................................................................38
P
Plugs
Manufacturers and suppliers ....................................33
Ordering information ...............................................26
Ordering Information ...............................................45
Power
Consumption ............................................................39
Dissipation ...............................................................23
Supply ......................................................................39
Principle Circuit Diagram CMA 56 ..............................21
Problems
Contact information .................................................48
R
Rear view CMA 56 .......................................................28
Rotary system switch .............................................. 22, 30
S
Safety ............................................................................44
Shock and Vibration .....................................................43
Signal processing ..........................................................20
Sliding switch ...............................................................30
Position of .................................................... 11, 22, 30
Software version ..................................................... 10, 12