9
Designated Use
1 Designated Use
The CMGPS is designed to either
• control one OMICRON CMC test set at a predetermined point in time
(triggering the starting point of a test process) or
• to synchronize the starting point of a test process of two or more
OMICRON CMC test sets.
by means of the GPS signal with world-wide reception.
The test set is controlled:
•via the ext. Interf. input
1
at the rear of the CMC test set
or
• via a binary input on the front of the CMC test set.
Using the CMGPS for other purposes than those described above is not
considered the designated use.
The CMGPS's specifications have been determined in the course of a project to
develop a mobile synchronization unit for CMC test sets. The CMGPS may not
be installed stationary.
Any other use of the CMGPS is only permitted after OMICRON electronics has
expressly agreed to it.
Observance of the operating instructions and compliance with the precautions
outlined therein is part of the defined use.
1. Refer also to section 3.3.3 ”ext. Interf.”.
To Next Page
Loading...
General