Omni Bead Ruptor 24 - Maintenance and Cleaning; Cleaning Guidelines and Warnings

25
SECTION 6 — MAINTENANCE
6.1 CLEANING THE BEAD RUPTOR 24
The housing of the unit can be cleaned with a sponge or damp cloth moistened with water or alcohol.
WARNING: For safety purposes and to prevent any damage of the unit, the recommendations listed below
should be strictly followed:
• DO NOT spray water or alcohol directly on the unit, expecially in the air vents and the fan
• ALWAYS disconnect the power cord before cleaning
• DO NOT use any type of scrapers
• DO NOT use caustic solvents or acetone. Harsh solvents can damage the nish of the housing and lid.
• DO NOT autoclave the nger plate. This will cause it to crack. Instead, wipe the space ngerplate down
with a damp cloth and a mild detergent.
Example of Decontamination Procedure
If a tube breaks when a run is in progress, decontaminate parts that may have been contaminated with an
appropriate disinfectant. The decontamination procedure is the sole responsibility of the user. Parts that
may have been contaminated can be cleaned with a sponge or a damp cloth moistened with a non-abrasive
cleanser.
In case another decontamination procedure is to be applied, please rst contact technical support to ensure
the compatibility of the new procedure with the instrument.