Omni Bead Ruptor 24 - Transport, Storage & Service; Transporting the Bead Ruptor 24

27
SECTION 8 — TRANSPORT, STORAGE & SERVICE
8.1 TRANSPORTING THE BEAD RUPTOR 24
The Bead Ruptor 24 must be shipped in its original packaging.
Before transporting the equipment, it is necessary to:
1. Close the lid of the Bead Ruptor 24 and cover with the plastic bag.
2. Align the slots on the bottom of the unit with the support hooks on the base of the shipping crate.
3. Lower the unit onto the hooks and slide it backward until the back of the unit touches the supporting edge.
4. Secure the unit to the support plate with the included knob screws. Tighten the screws as much as possible.
5. Place the cardboard box over the Bead Ruptor.
6. Use a screwdriver or power drill to secure the lid to the top of the crate.
PLEASE NOTE: The Bead Ruptor 24 MUST be shipped in its original packaging. Failure to do so can result in
serious damage to the unit and will void all warranties.
1. 2.
3.
4. 5. 6.