28
SECTION 8 — TRANSPORT, STORAGE & SERVICE
8.2 STORAGE
The unit can be used in a cold room, but it must be stored in a dry area at a temperature ranging from
0° C/32° F to 50° C/122° F
8.3 SERVICE
It is recommended that the speed of the Bead Ruptor 24 be calibrated annually to ensure maximum
operation. For this or any other product servicing please contact Omni International at 800.776.4431.
8.4 DECONTAMINATION REQUIREMENT
Should an instrument or component that has been used with radioactive or pathogenic material require
factory or eld service, comply with the following procedure to ensure the safety of service personnel:
Clean the parts to be serviced of all encrusted material and decontaminate them. There must be no radio-
activity detectable by survey equipment. Obtain a Decontamination Certicate from Omni International.
Complete the certicate and attach to the instrument or parts being returned.
If no Decontamination Certicate is attached, and a potential radioactive or biological hazard is detected or
suspected by Omni International, the equipment will not be serviced until proper decontamination and cer-
tication is complete. The sender will be contacted for instructions as to the disposition of the equipment.
Disposition costs will be borne by the sender.
WARNING: It is a violation of federal law to transport biologically hazardous or radioactive materials without
proper packaging, labeling, and appropriate warnings.
Please visit the web address below to register
your new Bead Ruptor. You will also be asked
to provide us with information about
your research. In return, we’ll send you
a Starbucks gift card!
Register today!
www.omni-inc.com/warranty
Register your Bead Ruptor & tell us about your research!
To Next Page
Loading...
