Subnet (Subnet Mask)
Accepts data in the form of four octets to describe the Ipv4 network subnet mask of the
Omnia.11’s network interface. The entries have the form of:
[ octet] . [ octet] . [ octet ] . [ octet] which when entered may appear as a network address such as:
255.255.255.0
Gateway
Accepts data in the form of four octets to describe the Ipv4 gateway address assigned to
the Omnia.11’s network interface. The entries have the form of:
[ octet] . [ octet] . [ octet ] . [ octet] which when entered may appear as a network address such as:
192.168.0.1
To change a setting, touch anywhere inside the white box for the setting you wish to change and the on-screen
keyboard will pop-up:
Use the on-screen keyboard to type in the desired addresses. You will need the number entry mode of the keyboard
so touch the “0-9*/=” button to shift the keyboard to that mode.
Touch just to the right of the current entry at the top of the keyboard to place the cursor at the end of the entry.
From this position, the backspace key
can be used to delete the desired number of characters or the entire
entry. Note that there is only a backspace key and no Delete key.
Once you have the new entry completed as desired, touch the OK key. To cancel without making any changes,
touch the CANCEL key.
To Next Page
Loading...
Need help?
General
