To proceed, click the “Continue” button to bring up the file “Browse” dialog:
Click the “Browse” button and select the .oup file you downloaded, and then click “Update” to upload the file into
the currently non-running software bank. This will not take you off the air since the software bank it is uploading to
will need to be selected and then the unit rebooted in order to run the new software.
Once initiated, you should see this screen:
Read the screen carefully, noting that the unit must not be interrupted while it is loading the update file, then click
the yellow “Click here to monitor the progress of the update” link and you should see the following screen that
contains a status box with which to monitor the status of the update:
To Next Page
Loading...
