26
The Stereo selection indicates that the processor will process a 2-channel stereo signal. Please note that the two
channels cannot be separate un-related signals since the processing is stereo strapped.
Mono L: The signal at the left input is fed to both the left and right channels of the processing.
Mono R: The signal at the Right input is fed to both the left and right channels of the processing.
Mono L+R: A sum of the two input channels is fed to both left and right channels of the processing.
Swap is similar to Stereo but the L & R channels are reversed. (swapped)
Pre-Emphasis (Omnia-3fm Turbo only)
See Omnia-3fm Turbo System Adjustments in chapter 4 for full details.
De-Emphasis (Omnia-3fm Turbo only)
See Omnia-3fm Turbo System Adjustments in chapter 4 for full details.
BS-412 Power Limiter (Omnia-3fm Turbo only)
See Omnia-3fm Turbo System Adjustments in chapter 4 for full details.
BS-412 Average Power (Omnia-3fm Turbo only)
See Omnia-3fm Turbo System Adjustments in chapter 4 for full details.
Asymmetrical Modulation (Omnia-3am only)
See Omnia-3am System Adjustments in Chapter 5 for full details.
Tilt EQ (Omnia-3am only)
See Omnia-3am System Adjustments in Chapter 5 for full details.
Tilt Frequency (Omnia-3am only)
See Omnia-3am System Adjustments in Chapter 5 for full details.
LPF Frequency (Omnia-3am only)
See Omnia-3am System Adjustments in Chapter 5 for full details.
LPF Frequency (Omnia-3net/drm only)
See Omnia-3net/drm System Adjustments in Chapter 6 for full details.
Stereo Generator (Omnia-3fm Turbo only)
Six parameters are set under this sub-menu: SCA Level, Composite 1, Composite 2, Pilot Level, Phase Adjust,
and Separation.
See Omnia-3fm Turbo System Adjustments in chapter 4 for full details.
Display
Two parameters are set under this sub-menu: Contrast and Backlight.
Contrast adjusts the brightness difference between the lightest and darkest segments in the front panel display.
Note that if this setting is mis-adjusted the display will “disappear.”
Backlight adjusts the LCD’s backlight to compensate for room brightness.
To Next Page
Loading...
Need help?
General
