Omnitronix DL100 User’s Manual
Page 18
Password indicates whether password protection is enabled for the current method being used to
access the command processor. For example, if passwords are disabled for modem and serial
connections but enabled for Ethernet, this item would indicate ON if connected to the DL100 via
Telnet. It would register OFF if connected via modem or serial.
Compress displays the status of the space compression used in line mode polling. This setting has
no bearing on Xmodem or CBB data release.
The Baud Rate and Parity settings table contains the baud, word length, parity, and stop bit
settings for each installed serial port.
File Records shows the number of carriage return-delimited records stored within the unit.
File Bytes represents the number of bytes the above records are occupying.
File % Full is a rough percentage indicator of how much data is stored in a particular file.
ASCII/Binary displays the current setting of whether or not ASCII or binary data is being stored
in a particular port’s file.
Handshake indicates the current method of handshaking for each port.
File Wrap indicates whether file wrapping is enabled on a particular port. This allows a unit to
fill up to 100% and then begin to overwrite the oldest records as new ones come in.
Alarm Filter shows which, if either of the alarm families are active on a port.
To Next Page
Loading...