22
USING THE MEMORY FUNCTION
Every time you complete a measurement, the monitor stores the blood pressure
and pulse rate in the memory. The monitor automatically stores up to 100 readings
(blood pressure and pulse rate). When 100 readings are stored, the oldest record is
deleted to save the most recent readings.
AVERAGING FUNCTION
The monitor calculates the average reading based on up to the three most recent
readings taken within 10 minutes.
NOTE: If two readings are stored in the memory for the 10 minute period, the
average is based on the two readings. If only one reading is stored, this is
displayed as the average.
TO DISPLAY YOUR READINGS
1. Press the Memory button ( ) to display the average reading based on the
three most recent readings taken within 10 minutes. The Average Reading
Symbol ( ) appears on the display when the average reading is shown.
2. Press the Memory button ( ) to display the readings from the most recent to
the oldest.
Alternating date/time
display
NOTES: • The Memory number appears for a second before the pulse rate is
displayed. The newest set is number “1”.
• If the Positioning indicator is set to “on” before the measurement, the
Positioning indicator is displayed with the readings.
• The date and time are alternately displayed with the readings.
• Press the Memory button ( ) repeatedly to display the next
readings.
• Press and hold the Memory button ( ) to display the readings
faster.
3. Press the START/STOP button to turn the monitor off.
TO DELETE ALL READINGS STORED IN THE MEMORY
You cannot partially delete readings stored in the memory. All readings will be
deleted.
1. Press the Memory button ( ) to turn the monitor on.
2. While holding the Memory button ( ), press the START/STOP button down
for more than 2 seconds until the display appears as it does in the following
illustration.
3. Press the START/STOP button to turn the monitor off.
NOTE: The monitor will automatically turn off after two minutes.
To Next Page
Loading...
