Example of Parameter Settings
Note 1: To cancel the set value, press the Mode Key instead, The parameter number will be
displayed.
2: There are parameters that cannot be changed while the Inverter is in operation. Refer to the
list of parameters. When attempting to change such parameters, the data display will not
change by pressing the Increment or Decrement Key.
8 Multi-step speed reference 3 15 Undervoltage in progress
10 Inching Command
Analogue Output Functionsts
12 External base block (NO)
Value
*1
Function
13 External Base block (NC) 0 Otput frequency
17 Local/Remote selection 1 Output current
*1 Refer to user’s manual for full set value
Key
Sequence
Indicator Display example Explanation
Power On
Press the Mode Key repeatedly until the PRGM indicator
is lit.
Use the Increment or Decrement Key to set the parameter
number.
Press the Enter Key. The data of the selected parameter
number will be displayed.
Use the Increment or Decrement Key to set the data.
At that time, the display will flash.
Press the Enter Key so that the set value will be entered and the
data display will be lit (see note 1)
In approximately
1s.
The parameter number will be displayed.
Multi-function Inputs Multi-function Outputs
Value
*1
Function Value
*1
Function
In approximately 1s.
Cancels
Set Data
To Next Page
Loading...
