4 - 3
4 Installation and Wiring
E3NW-ECT EtherCAT Digital Sensor Communication Unit Operation Manual (E429)
4-1 Mounting E3NW-ECT and Sensor Amplifiers
4
4-1-2 Removal Method
Do not perform steps 1 and 2 in the reverse order. This
may reduce the mounting strength.
After you finish these steps, make sure the E3NW-ECT is securely in place.
Use the following procedure to remove the Units.
1. Slide the Sensor Amplifier Units away and remove the Sensor Communication Unit first.
2. Keep the Sensor Communication Unit pressed against the DIN Track as you lift it up, and then off.
4-1-2 Removal Method
Perform step 1 and
then step 2.
Do not perform step
2 before step 1.
To Next Page
Loading...
Need help?
General
