136
Advanced Function Setting Level Section 5-7
• When this parameter is set to ON, the heater burnout alarm is held until
either of the following conditions is satisfied.
a Heater burnout detection is set to 0.0 A.
b The power is turned OFF then back ON again (i.e., power is reset).
• Output is turned OFF when switching to the initial setting level, communi-
cations setting level, or advanced function setting level.
Related Parameter
HB ON/OFF (advanced function setting level): Page 135
• This parameter sets hysteresis for heater burnout detection.
Related Parameter
HB ON/OFF (advanced function setting level): Page 135
hbl Heater Burnout Latch
Heater burnout and HS alarms must
be supported.
Alarm 1 must be assigned.
The “heater burnout detection”
parameter must be set to ON.
Setting range Default
on: Enabled, off: Disabled off
Function
Setting
See
See
hbh Heater Burnout Hysteresis
The “heater burnout” parameter must
be set to ON.
The “heater burnout latch” parameter
must be set to OFF.
Heater burnout and HS alarms must
be supported.
Alarm 1 must be assigned.
Setting range Unit Default
0.1 to 50.0 A 0.1
Function
Setting
See
See
■
■
To Next Page
Loading...
Need help?
General
