Omron E5CN

6.1 Variable Area (Setting Range) List
6-9
0E14 Event input assignment 1 H'00000002 (2): Auto/Manual (Cannot be set if the “Number
of multi-SP uses” is set to 1 or 2.)
H'00000003 (3): Program Start (Cannot be set if the “Num-
ber of multi-SP uses” is set to 1 or 2.) (See
note 6.)
Advanced
function
setting
0E16 Event input assignment 2 H'00000000 (0): None
H'00000001 (1): RUN/STOP (Cannot be set if the “Number
of multi-SP uses” is set to 2.)
H'00000002 (2): Auto/Manual (Cannot be set if the “Number
of multi-SP uses” is set to 2.)
H'00000003 (3): Program Start (Cannot be set if the “Num-
ber of multi-SP uses” is set to 2.) (See note
6.)
0E20 Alarm 1 assignment H’00000000 to H’00000006 (0 to 6) (Same settings as the
control output 2 assignments)
0E22 Alarm 2 assignment H’00000000 to H’00000006 (0 to 6) (Same settings as the
control output 2 assignments)
0E28 Transfer output upper
limit
H'FFFFF831 to H'0000270F (−1999 to 9999) (See note 4.) Initial set-
ting
0E2A Transfer output lower
limit
H'FFFFF831 to H'0000270F (−1999 to 9999) (See note 4.)
Address Parameter name Setting (monitor) value Level