Omron Focus PM710-M - Cleaning Device Components; Cleaning the Knee Pad; Cleaning the Knee Band; Cleaning the Main Device Unit

24
4.1 Cleaning
3
Place the pad onto the pad holder to
allow the adhesive surface to air-dry.
• Do not wipe the adhesive surface with
tissue or paper-based cloth.
• If the adhesive surface is too wet, turn it
over and let it air dry before placing the
pad onto the pad holder.
Pad
holder
4.1.3 Cleaning the Band
1
Remove the device and pad from the band.
2
Hand-wash and air-dry it in a shaded area.
• Wash the band by hand according to the instructions indicated on the band.
• Do not soak the band in water for long periods of time.
• Align the shape of the band while letting it dry.
• Repeated washing may gradually change the color and sheen of the band.
• Do not use any sterilization chemicals, disinfectants, or softeners.
4.1.4 Cleaning the Device
1
Turn the device off.
2
Wipe the surface of the device with a soft cloth that has been
lightly moistened with water or mild detergent, then dry
completely using a soft cloth.
• Do not use chemicals such as thinners and benzenes to clean the device.
• Do not let water get into the internal area of the device.