1616
SETTING THE POSITION SENSOR ALARM
The Position Sensor Alarm emits sound to help you place your wrist in the
correct position. The Position Sensor Alarm can be set to ON or OFF
when the APS is set to ON. The Position Sensor Alarm is set to ON1 at
the time of purchase.
The alarm set to “ON1” emits a series of blips when your wrist is too far
away from the correct measuring position and beeps slowly once your
wrist is in the correct position.
The alarm set to “ON2” beeps only once your wrist is in the correct
position.
1. TO CHANGE THE SETTING
Press the START/STOP button to turn the
power off, then press the SET button twice.
The Position Sensor Alarm symbol ( ) will
appear on the display.
2. SELECTING ON1, ON2, OR OFF
Press the MEM button to change the setting to “ON2”, “OFF” and
“ON1”.
3. CONFIRM THE SETTING
Press the START/STOP button to confirm the alarm function you
selected and to turn the monitor off.
To Next Page
Loading...
