18
SETTING THE DATE AND TIME
Set the monitor to the current date and time before taking a measurement
for the first time. If the date and time are not set correctly, the
measurement values stored in the memory will have the wrong date and
time.
Set the date and time in the following situations:
1. Before you use the monitor for the first time
2. After battery replacement
1. TO CHANGE THE SETTING
Press the START/STOP button
to turn the power off, then press
the SET button four (4) times.
The year flashes on the display with the
current setting.
2. SETTING THE YEAR
The year can be set between 2004 and 2030.
When the display reaches 2030, it will return to 2004.
Press the MEM button to advance by
increments of one year.
NOTE: Press and hold the MEM button to
increase the values faster.
To Next Page
Loading...
