Omron HN300T2 Intelli IT - Before Taking a Measurement; Installing and Replacing Batteries; Selecting the Weight Metric

1. Installing Batteries
1
Open the battery cover on the back of
the scale.
2
Install the batteries following the
correct polarities as shown to the right
and inside the battery compartment.
3
Close the battery cover.
Note
• Place the scale on a hard, flat and level floor immediately after installing the batteries. The scale is calibrated
automatically.
• When the “
” symbol and “A1” appear, replace all 4 batteries with new ones. Items stored in memory will
be saved even if the batteries are removed.
• Disposal of used batteries should be carried out in accordance with your local regulations for the disposal of
batteries.
2. Selecting the Weight Metric
1
When the scale is off, press
the [SET] button to select
your preferred weight metric
“kg”, “lb” or “st”.
Weight is set to “kg” as the default
metric.
The weight metric will be saved after
10 seconds.
The scale will automatically turn off
after 3 seconds.
7
Before Taking a Measurement