Linear Sensor Indicator K3HB-S 19
The range shown in dark shading indicates the factory setting.
Sampling and Comparative Output Response Times
The K3HB-S sampling and comparative output response times depend on the calculation methods, timing hold type, and, for simple averaging, the
averaging times. Refer to the following description for details.
■ Output Refresh Period
The K3HB-S repeats input reads, calculation, and judgement output
processing. The output refresh period differs depending on whether
there are one or two inputs, as outlined below.
One Input
Two inputs
■ Output Response Time
The comparative output response time is the sum of the data pro-
cessing time and the output (relay or transistor) response time.
One Input
Two Inputs
Note: For transistor outputs:
For one input: OFF to ON 1 ms and ON to OFF 1.5 ms
For two inputs: OFF to ON 2 ms and ON to OFF 2.5 ms
For relay outputs:
The relay operation time of 15 ms is added to the transistor
output response times.
Input type DC current input Input type DC voltage input
Connected terminals 0-20 4-20 Connected terminals 0-5 1-5 5 10
Input A in-ta Input A in-ta
Input B in-tb Input B in-tb
DC current
range (mA)
24.000
20.000
16.000
12.000
8.000
4.000
0.000
−4.000
22.000 22.000 DC voltage
range (V)
10.000
5.000
0.000
−5.000
−10.000
11.000
5.500 5.500 5.500
−0.500 0.500
−5.500
2.000
−11.000
−2.000
E2 E3 E4 E3
E1 E3 E5 E3
Input A
or
Input B
Input read
Output
refresh
Every 0.5 ms
Every 0.5 ms
0.5 ms
Input
↓
↓
Output
0.5 ms
Input
↓
↓
Output
0.5 ms
Input
↓
↓
Output
Input
↓
↓
Output
Input
↓
↓
Output
Input
↓
Input A
or
Input B
Output
refresh
Input B: Every 1 ms
Input read
Input A: Every 1 ms
Every 0.5 ms
0.5 ms
Input
↓
Output
0.5 ms
Input
↓
Output
0.5 ms
Input
↓
Output
Input
↓
Output
Input
↓
Output
Input
↓
Output
Input
↓
0.5 ms 0.5 ms
R
R Output response time
(See note.)
Data processing time
R R
0.5 ms
R Output response time
(See note.)
Data processing time
R R RR
0.5 ms 0.5 ms 0.5 ms 0.5 ms
To Next Page
Loading...
