Omron M2 - Applying the Arm Cuff

14
3.Using the Unit
3.2 Applying the Arm Cuff
Be sure to wrap the arm cuff correctly so that you get accurate results.
Measurements can be taken in light clothing. However, please remove
thick clothes, such as sweaters, before taking a reading.
1. Insert the air plug into the air
jack on the left side of the
main unit.
2. Put your left arm through the
cuff loop.
Note: If the cuff is not
assembled, pass the
end of the cuff furthest
from the tubing through
the metal D-ring to form
a loop. The smooth
cloth should be on the
inside of the cuff loop.
HEM-7117-E_main.book Page 14 Friday, May 14, 2010 8:43 AM