EasyManuals Logo

Omron NJ Series Network Connection Guide

Omron NJ Series
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
6. EtherNet/IP Settings
12
Allocation of EIPOutput.CommonControlFlag.F variable
Offset
(word)
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
+0
SYNC
EXE
+1
ERCLR
EXE: Control command execution bit: Turns ON when the Controller
instructs execution of control commands to the displacement sensor.
SYNC: Measurement synchronous start bit: Turns ON when the Controller
instructs measurement synchronization to the displacement sensor.
ERCLR: Error clear bit: Turns ON when the displacement sensor ERR
signal turns OFF.
Allocation of EIPOutput.CommonControlFlag.W variable
Offset
(word)
15 14 13 2 1 0
+0 15 14 13 2 1 0
+1 31 30 29 18 17 16
Bits 31 to 0: EIPOutput.CommonControlFlag.W uses DWORD data from the
offset +0 word.
*5: Details on allocation of sensor head 1 control signal
Allocation of EIPOutput.SensorHead1ControlFlag.F variable
Offset
(word)
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
+2
LIGHT
OFF
RESET1
TIMING1
+3
ZEROCL
R_T4
ZEROCL
R_T3
ZEROCL
R_T2
ZEROCL
R_T1
ZERO1_
T4
ZERO1_
T3
ZERO1_
T2
ZERO1_
T1
TIMING1: Timing bit: Turns ON when the Controller instructs start of hold
sampling to the displacement sensor.
RESET1: Reset bit: Turns ON when the Controller resets judgment
processing and output of the displacement sensor. If the hold
function is used, the state before the hold function was set will be
restored.
LIGHTOFF1: Light metering OFF bit: Turns ON when the Controller
instructs logical beam OFF to the displacement sensor.
ZERO1_T1 to 4: Zero reset execution bit: Turns ON when the Controller
instructs execution of zero reset of TASK1 to 4 to the
displacement sensor.
ZEROCLR1_T1 to 4: Zero reset cancel bit: Turns ON when the Controller
instructs zero reset cancel of TASK1 to 4 to the displacement
sensor.

Other manuals for Omron NJ Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NJ Series and is the answer not in the manual?

Omron NJ Series Specifications

General IconGeneral
Program CapacityUp to 128 MB
SD Card SlotYes
Power Supply Voltage24 VDC
Motion ControlYes
USB Ports1
Operating Temperature0°C to 55°C
Communication InterfacesEthernet/IP, EtherCAT, USB
Safety FunctionOptional
Storage Temperature-20°C to 75°C
Communication PortsUSB
DimensionsVaries by model
WeightVaries by model

Related product manuals