Step Description Reference
Step 7-2 Troubleshooting
Errors If They Occur
If an error occurs, use the troubleshooting func-
tion of the Sysmac Studio to check the error and
determine the cause. Then, remove the error.
S
ection 12 Troubleshooting on
page 12 - 1
Step 7-3 Inspection and
Replacement
Perform periodic maintenance.
If you find any defects or problems during the in-
spection, replace the affected devices.
S
ection 13 Inspection and
Maintenance on page 13 - 1
1 Overview
1 - 20
NX-series Safety Control Unit User's Manual (Z930)
To Next Page
Loading...
