• When you transfer the data through the NJ/NX-series CPU Unit without using the Sysmac Studio’s syn-
chronization operation.
• When you transfer the data with the Sysmac Studio connected to the USB port on the Communications
Coupler Unit
The restart may cause the EtherCA
T master to detect an error. If an error is detected, you need to reset the
error in the EtherCAT master.
*3. Supported only by Sysmac Studio version 1.10 or higher.
Version Information
You can download safety-validated safety application data with Sysmac Studio version 1.10 or
higher and NX-SL££££ version 1.1 or later.
7 Checking Operation and Actual Operation
7 - 6
NX-series Safety Control Unit User's Manual (Z930)
To Next Page
Loading...
