Omron NX-SL5500

13
Inspection and Maintenance
This section describes the procedures for cleaning, inspecting, and replacing Safety
Control Units.
13-1 Cleaning and Inspection
............................................................................ 13 - 2
13-1-1 Cleaning...................................................................................................... 13 - 2
13-1-2 Periodic Inspections.................................................................................... 13 - 2
13-2 Maintenance Procedures........................................................................... 13 - 5
13-2-1 Replacing the Safety CPU Unit................................................................... 13 - 5
13-2-2 Replacing Safety I/O Units.......................................................................... 13 - 7
13 - 1
NX-series Safety Control Unit User's Manual (Z930)
13