Appendices
A - 132
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User’s Manual (I586)
Event name Motor Non-conformity Event code 246D0000 hex
Description The Servo Drive and motor combination is not correct.
Source
EtherCAT Master Function Mod-
ule
Source details
Slave
Detection
timing
At power ON
Error
attributes
Level
Minor fault
Recovery
Error reset
(after cycling
slave power)
Log category
System log
Effects User program Continues. Operation Power drive circuit is OFF
Indicators
EtherCAT NET RUN EtherCAT NET ERR EtherCAT LINK/ACT
--- --- ---
System
-defined
variables
Variable Data type Name
None None None
Cause and
correction
Assumed cause Correction Prevention
The Servo Drive and motor com-
bination is not correct
Replace the motor with one that
matches the Servo Drive.
Use a motor that matches the
Servo Drive.
Attached
information
Attached Information 1: Cause Details
1: Error at a time when the capacity of the connected Servomotor does not conform to the capacity of Servo
Drive.
2: The Servomotor with different operating voltage is connected.
Precautions/
Remarks
AL status code: -, Error No.: 9501 hex
To Next Page
Loading...
Need help?
General
