Omron SRM1-C01-V2 - Page 35

SRT2-VID/VOD
SRT2-VID/VOD
44
Nomenclature
SRT2-VID08S/SRT2-VID08S-1
SRT2-VOD08S/SRT2-VOD08S-1
(Sensor Connector Models)
SRT2-VID16ML/SRT2-VID16ML-1
SRT2-VOD16ML/SRT2-VOD16ML-1
(MIL Connector Models)
Communications
Connectors
I/O Connectors
Indicators
DIP Switch
Communications
Connectors
I/O Connectors
Output HOLD/CLEAR Mode Setting
Communications Mode Setting
Node Address Setting
Reserved for System Use (Always OFF)
Indicators
Indicator DisplayColor Meaning
PWR LitGreen The communications power
supply is ON.
Not lit The communications power
supply is OFF.
COMM LitYellow Normal communications
Not lit A communications error has
occurred or the Unit is in
standby status.
ERR LitRed A communications error
has occurred.
Not lit Normal communications or
the Unit is in standby status.
0 to 7
(for
8-point
I/O)
0 to 15
(for
16-point
I/O)
LitYellow The corresponding I/O
signal is ON.
Not lit The corresponding I/O
signal is OFF.
Name
Power
Commu-
nications
Commu-
nications
error
Input
(output)
Output HOLD/CLEAR Mode
SW8 (HOLD) Setting
Output status is cleared.OFF
Output status is maintained.ON
Communications Mode
SW7 (HOLD) Setting
High-speed communications modeOFF
Long-distance communications modeON
Node Number Settings
Node number Pin 4 Pin 3 Pin 2 Pin 1
8421
0 OFF OFF OFF OFF
1 OFF OFF OFF ON
2 OFF OFF ON OFF
3 OFF OFF ON ON
4 OFF ON OFF OFF
5 OFF ON OFF ON
6 OFF ON ON OFF
7 OFF ON ON ON
8 ON OFF OFF OFF
9 ON OFF OFF ON
10 ON OFF ON OFF
11 ON OFF ON ON
12 ON ON OFF OFF
13 ON ON OFF OFF
14 ON ON ON OFF
15 ON ON ON ON
Note: Be sure to perform settings with the Slave
power supply OFF.