SRT1-IDjP/ODjP
SRT1-IDjP/ODjP
78
Installation
Internal Circuit Configuration
SRT1-ID16P SRT1-OD16P
Internal circuit
Internal circuit
External Connections
Communications
Two-wired
proximity
sensor
BS– or G
Input Module (SRT1-ID16P)
Output Module (SRT1-OD16P)
Communications
Relay
Internal circuit
Internal circuit
D1:
Reverse voltage prevention diode
Note: NC in parentheses is for the Input Modules
.
Node Number Settings and
Output HOLD/CLEAR Mode
Internal circuit
BS–
or G
Note: Refer to the
CompoBus/S Operation Manual (W266)
for
details
on the switch.
Indicators
R:
LED current limiting resistor
LED1:
LED for COMM
LED2:
LED for ERR
The maximum current for LED1 and 2 is 10 mA.
Internal circuit
The
5-V Output T
erminals have positive power supplies (maximum
output current of 20 mA) for the ERR and COMM LEDs. Recom-
mended
LED colors are red for ERR and yellow for COMM.
To Next Page
Loading...
