Omron STC-MBS500POE

No.18S111-03
60/70
STC-MBS500POE / STC-MCS500POE
Product Specifications and User’s Guide
11.3 AcquisitionControl
Name Description
AcquisitionMode Sets the acquisition mode of the device.
AcquisitionStart Starts the Acquisition of the device.
AcquisitionStop Stops the Acquisition of the device at the end of the current Frame.
AcquisitionFrameCount Number of frames to acquire in Multi Frame Acquisition mode.
AcquisitionFrameRate Controls the acquisition rate (in Hertz) at which the frames are
captured.
TriggerSelector Selects the type of trigger to configure.
TriggerMode [TriggerSelector] Controls if the selected trigger is active.
TriggerSoftware [TriggerSelector] Generates an internal trigger.
TriggerSource [TriggerSelector] Specifies the internal signal or physical input Line to use as the trigger
source.
TriggerActivation [TriggerSelector] Specifies the activation mode of the trigger.
TriggerDelay [TriggerSelector] Specifies the delay in microseconds (us) to apply after the trigger
reception before activating it.
ExposureMode Sets the operation mode of the Exposure.
ExposureTimeSelector Selects which exposure time is controlled by the Exposure Time
feature.
ExposureTime
[ExposureTimeSelector]
Sets the Exposure time when Exposure Mode is Timed and Exposure
Auto is Off.
ExposureAuto Sets the automatic exposure mode when Exposure Mode is Timed.
ExposureAutoLimitMin Determine the lower limit of exposure time when Exposure Auto is set
to Continuous.
ExposureAutoLimitMax Determine the upper limit of exposure time when Exposure Auto is set
to Continuous.